1, hit the jeans, with a little force can be opened, the bottom nail and button is not firm
If it is the glue jeans button, which has a relationship with the glue jeans button, if the use of a little plastic as the glue, it will not be able to withstand the pressure from the bottom nail, will squeeze open. So we pull hard and it falls off. With good plastic-new material, that won’t happen. At the same time, there is a relationship with the shape of the bottom nail, there are spikes, there are threaded nails, in general, the use of threaded nails.
2, the bottom nail into the inside of the button, directly through the panel
A simple analysis shows that the jeans button panel is made too thin. It can’t bear the impact of the nail, and it can punch through the button face. This situation is less, like alloy, copper, iron jeans buttons, do ordinary is also very rare, unless deliberately hard to hit down, will hit the face through.
When the jeans button is fastened to the jeans, the surface will lose color
In fact, this problem is also relatively simple, the surface color of jeans buttons, which is generally related to electroplating and spray painting, plating is not good, there is no oil sealing products, the color is generally not long, after oxidation in the air, the color will become light, but also in the process of friction will fall off. In the case of spray paint, paint off, which is related to the composition of the paint of the product spray paint, good paint generally will not fall off, unless it is a very bad paint.
4, jeans button surface rough
This problem of buttons is related to the surface treatment process of the factory. The polishing is not in place and the mold of the product is not opened well. If these points are done well, they can be completely avoided.
There are also jeans buttons according to different customer requirements, such as glue dripping, paint spraying, hanging plating, etc. the problems also depend on the specific situation.
